CTU portable rainfall simulator
Katedra hydromeliorací a krajinného inženýrství, Fakulta stavební ČVUT v Praze
Zdroj financování: Glyfosáty Erosion-3D
dry
precipitation start:
10:30
precipitation
set rainfall intensity
| time | rainfall intensity [mm.h-1] | Note |
|---|
soil moisture
| time | plot X coordinate [m ] | plot Y coordinate [m ] | volumetric soil moisture [%V] | Note |
|---|
Derived from record(s) #2056
average value from point measurements within the experimental plot
| time | volumetric soil moisture [%V] | Note |
|---|
dry
very wet
precipitation start:
11:23
winter wheat
Zal. : 08.04.2020 (Exp. plot #57 [36])
- Note:
- surface runoff generated only on bottom 1,5m of the experimental plot (the runoff almost stopped when the nozzle flow rate was measured); the measurement continued to get at least some data ...
- delay till the surface runoff:
- 00:30:00
- Precipitation intensity:
- 60.0 mm.h-1
- Initial moisture:
- 37.7 %V
- Organic carbon soil sample
- 2 (assigned by necessity)
- Bulk density soil sample
- 46 (assigned by similarity)
- Soil texture sample
- 39 (direct measurement)
surface run-off
| time | flow rate [l.min-1] | Note |
|---|
sediment load
| time | suspended solids concentration [g.l-1] | Note |
|---|
precipitation
set rainfall intensity
| time | rainfall intensity [mm.h-1] | Note |
|---|
soil moisture
| time | plot X coordinate [m ] | plot Y coordinate [m ] | volumetric soil moisture [%V] | Note |
|---|
Derived from record(s) #2058
average value from point measurements within the experimental plot
| time | volumetric soil moisture [%V] | Note |
|---|
Erosion-3D model parameters
derived by R_E2D by Jonas Lenz
| time | skinfactor endinf [-] | Note |
|---|
| time | skinfactor runoff [-] | Note |
|---|